Mira Elit ST 9KW electric shower

The Mira Elite ST is a tank-fed (cistern-fed) pumped electric shower for use where the mains water supply pressure is too low, unreliable or non existent, to operate a conventional electric shower.
The Mira Elite ST features an internal pump unit which has been designed to provide all year round performance, even at the highest flow rates which are necessary during the summer months. The Elite ST has separate controls for power selection and temperature/flow adjustment. The Elite ST must have its own separate cold water supply from the cistern to ensure correct operation.
Manual temperature control
Separate power and flow/temperature controls with push button start/stop
Select & Forget controls
Four spray showerhead with rub clean rubber nozzles for easy cleaning
Integral pump for strong & consistent flow at all temperatures
Sensi-flo protects the user by switching off the heat if the flow is obstructed
Clearscale reduces limescale by half for better performance and longer life
Opti-flo delivers up to 50% more flow in the summer than conventional electric showers
Delayed shutdown turns off the shower gradually, flushing hot water from the tank for safer showering for the next user and reduced limescale

Guarantee

For domestic installations, Mira Showers guarantee the Mira Elite ST against any defect in materials or workmanship for a period of two years from the date of purchase (shower fittings for one year).
For non-domestic installations, Mira Showers guarantee the Mira Elite ST against any defect in materials or workmanship for a period of one year from the date of purchase.

Plumbing

The 15 mm inlet compression connector incorporates an inlet filter. The inlet swivels to allow top, bottom or rear entry.
Note! Whilst bottom entry is possible it is not recommended as it may encourage airlocks.
The outlet terminates with a 1/2" BSP male thread for connection to a Mira flexible shower hose.

The Elite ST is designed to operate with gravity fed water supplies providing pressures from 0.008 bar to 1 bar (10 metres head) (i.e. the vertical distance from the base of the cold cistern to the top of the Elite ST). The unit should be never be fitted to a mains supply or where the above maximum pressure may be exceeded. Failure to comply with this may result in product damage leading to significant uncontrolled leakage from the unit.

Standards and Approvals

The Mira Elite ST has been designed to comply with the requirements of the British Electrotechnical Approvals Board (BEAB) and the requirements of UK Water Regulations/Bye-laws (Scotland).
This Mira Elite ST complies with all relevant directives for CE marking.

Electrical requirements

This is a high power unit, it is essential to contact your electricity supply company to make sure that the electricity supply is adequate for the purpose.
The terminal block will not accept cable larger than 16 mm sq
The minimum required supply cable size must conform to BS 7671.
The following power ratings for the heater tanks are available with their respective voltages:
Mira Elite ST 9.8 kW @ 240 V / 45 Amps (9.0 kW @ 230 V / 40 Amps).
Mira Elite ST 10.8 kW @ 240 V / 45 Amps (9.9 kW @ 230 V / 45 Amps).

Mira showers.All the convenience of electric showering, from a low pressure stored supply. With its integral pump, Elite ST brings you unbeatable performance. The Mira Elite ST is ideal for areas where mains water pressure is either too low or erratic to operate a standard electric or mixer shower.

Adjustable riser	Yes
Easy clean head	Yes
Features	Manual temperature control
Head function	4 spray head
Model	1.1674.001
pipe size required	15mm
Rail kit included	Yes
Suitible for	Low pressure
Warranty	2 Years
WRAS approved	Yes
Manufacturer	Mira
Soap dish	Yes

Show all answers

Name

Location

E-mail Address

Question

100 characters remaining

Full explanation of question