Mira Event XS Power shower

The Mira Event XS is a surface mounted all-in-one manual power shower. It is designed for use with a mains voltage electrical supply and gravity fed hot and cold water supplies. It features a built-in pump unit, manual mixer assembly and separate controls for flow and temperature.
The product is fitted with a 15 mm dual entry push-fit inlet manifold which allows pipe connections to the top, bottom or rear of the power shower. The inlet manifold also contains inlet filters and check valves.
The shower control is supplied with Mira Logic power shower fittings. These fittings consist of an adjustable spray handset with four different spray actions (start, champagne, massage and economy), flexible hose, adjustable clamp bracket assembly, slide bar and supports, hose retaining ring and wall mounted soap dish. The fittings are available in a white/chrome or all white finish.
The Mira Event XS is not suitable for use in institutional/commercial applications. It must not be used with mains water pressure applications; for example, instantaneous electric heaters, instantaneous gas water heaters, unvented mains pressure systems, pumped shower systems and some combination-type storage systems.

Slim and stylish, the Mira Event XS offers safe and powerful showering, and a range of practical features.
Manual temperature control
Separate flow and temperature controls with push button start/stop
Select & Forget controls
Four spray showerhead with partial rub clean rubber nozzles for easy cleaning
Flow rate of up to 14 litres per minute

Guarantee

Mira Showers guarantee the Mira Event XS against any defect in materials or workmanship for a period of one year from the date of purchase.

Plumbing

Inlet 15 mm Push-fit inlet manifold.
Outlet 1/2" BSP to BS2779.
Maximum recommended inlet pressure - 0.5 bar or 5 m
Minimum Flow Rate - 8 l/Min (with a static inlet pressure of 0.1 bar).
Maximum Flow Rate - 14 l/Min (with a static inlet pressure of 0.1 bar).
The shower control must be fed from a cold water storage cistern and hot water cylinder providing nominally equal pressures.
The storage cistern should have a minimum storage capacity of 230 litres to provide adequate showering time. Insufficient storage may result in the pump being run dry.

Standards and Approvals

The Mira Event XS complies with all relevant directives for CE marking.

Electrical requirements

Appliance power supply 230?40 V, 50 Hz, fused at 3 Amps, via a double pole switched fused connection unit (not supplied) with a minimum 3 mm contact separation in each pole.
Power supply connection The Mira Event XS is fitted with a terminal block which will accept cable up to 2.5 mmï½². Minimum cable size (cross-sectional area) required under normal installation conditions is 1 mm sq
Absorbed power - Approximately 150 W under normal working conditions.
The mains supply must be 230-240 V at 50 Hz connected to the appliance via a double pole switched 3 Amp fused connection unit (not supplied) with a minimum 3 mm contact separation gap in each pole.
Fuses do not give personal protection against electric shock.
The Mira Event XS must be earthed by connecting the supply-cable earth conductor to the earth terminal.
Supplementary bonding: Within the bathroom or shower room, all accessible conductive parts of electrical equipment and extraneous conductive parts that are likely to introduce earth potential, must be electrically bonded to earth using a minimum cable size of 4.0 mm sq if the cable is not mechanically protected (2.5 mmsq if mechanically protected).

Mira showers.Slim and stylish, the Mira Event XS offers safe and powerful showering, and a range of practical features.

Adjustable riser	Yes
Anti-scald device	No
Easy clean head	Yes
Features	Manual temperature control
Head function	4 spray head
Model	1.1532.014
pipe size required	15mm
Rail kit included	Yes
Suitible for	Low pressure
Warranty	1 Year
Finish	White
Manufacturer	Mira
Soap dish	Yes

Name

Location

E-mail Address

Question

100 characters remaining

Full explanation of question